PsClearBreakPointFilters

Removes all previously set breakpoint filters.

Syntax

PULSE_STATUS PsClearBreakPointFilters(
[in] PPS_ENGINE pEngine,
[in] uint16_t BreakPointId
);

PPS_ENGINE pEngine

An opaque handle to an engine created by the EngCreateEngine function.

uint16_t BreakPointId

The ID of the breakpoint from which the filters are to be cleared. The breakpoint must have been previously set using the PsSetBreakPoint function.

If the function succeeds, the return value is PULSE_STATUS_SUCCESS.

If it fails, it returns one of the PULSE_STATUS values. Possible return codes include, but are not limited to, the following:

PULSE_STATUS_INSUFFICIENT_RESOURCES 0xC0000002	One of the memory allocations failed during initialization.
PULSE_STATUS_READ_FAILED 0xC0000003	Transport communication failed during a read operation.
PULSE_STATUS_WRITE_FAILED 0xC0000004	Transport communication failed during a write operation.
PULSE_STATUS_TIMEOUT 0xC0000007	Might happen if Transport I/O timed out. No response was received from the debuggee within the request timeout period.
PULSE_STATUS_INVALID_PARAMETER 0xC0000010	Might happen if The pEngine parameter is NULL.
PULSE_STATUS_INVALID_PACKET 0xC0000031	An invalid or unexpected packet was received in response.
PULSE_STATUS_TARGET_NOT_STOPPED 0xC0000045	An attempt was made to remove the breakpoint while the target was running.
PULSE_STATUS_DEVICE_CONNECTION_LOST 0xC0000308	The connection to the transport was lost. Try restarting the engine or the transport.

Breakpoint filters can be cleared only while the target is stopped.